BACK

The SQ Flex Wind system is based on wind energy as the only energy source for pump operation. The system is suitable for installation in areas where the wind is almost constant, seen over a period of time. As the turbine noise level increases with an increase in wind speed, siting of the wind turbine near a residence is not recommended.

The IO 102 breaker box makes it possible to brake the wind turbine when there is no need for water pumping, the system require service or during extreme wind occurences. This system also have the following benefits:

• ease of installation
• a minimum of maintenance is required
• few and simple components

Typical SQ Flex Wind system configuration

 

	1 - SQF pump
	2 - Pump cable
	3 - Cable clips securing cable
	4 - Safety rope
	5 - Wire clamp
	6 - Solar array
	7 - Solar array support structure
	8 - H80 wind turbine
	9 - IO 102 breaker box

IO 102 Breaker box A very simple and easy-to-use system and with cable interface.

H80 WIND TURBINE Produces high voltage DC output to power the SQFlex pump at maximum efficiency. It can be used in combination with GF43 Solar Module. Startup wind speed of only 7MPH and peak output of 900W, make the H80 Turbine an excellent choice in a wide variety of locations.