Trace
Engineering introduces the new T240 autotransformer. This
powerful compact unit can be used in several ways:
Step Up: Allows you to power 240 VAC loads from
a single 120 VAC inverter/charger. This is typically done
for powering deep well pumps or other dedicated high power
240 VAC loads.
Step Down: Allows you to connect a large 120 VAC
load to the output of a stacked pair of DR or SW inverters
(120/240 VAC). This results in the inverters sharing the
load, allowing higher performance and efficiency.
Balancing Transformer: Allows a single 120 VAC
inverter to be connected to a generator which has 240 VAC
output. Keeps the generator balanced for better performance
and operating life. Balancing the generator’s output also
allows higher charge rates from your battery charger
Includes an indoor powder coated enclosure with
knock-outs for conduit connections.
Includes a two pole 25 amp circuit breaker / disconnect
Up to six additional Square D QOU breakers can be added
for additional input/output wiring protection.
Note: This T240 replaces the old Trace model T220
Note:
Products are listed by UL and/or ETL to UL specifications
Specifications
Power
rating
4500
VA continuous @ 25 deg C ambient
AC
Input voltage
120/240
+/- 10% @ 60Hz
Idle
power consumption
12
watts (typical)
Insertion
loss
Less
than 4 VAC @ 4500VA
Input/output
AC breaker rating
25
amp 2 pole Square-D QOU Branch circuit rated/10,000AIC
Actual
weight
39.4
lbs. - (17.9 kg)
Dimensions
43.7
Ibs - (19.8 kg)
Enclosure
6.3"H
x 21 "L x 7.0"D (16cm x 53.3cm x 17.8cm)
Hookup
wire size
14
AWG to 2 AWG
Hookup
access
3/4"
and 1" Knockouts
Contact SWPV any time
for more information, quotations or consultation
Trace
Engineering introduces the new T240 autotransformer. This
powerful compact unit can be used in several ways:
