Now it's easier to meet National Electric Code requirements with a Trace DC175 or 250. These modules are designed to link with Trace SW and DR series inverter systems.

Battery disconnect: An easy way to isolate inverter and battery

• Meets National Electrical Code requirement for "means of disconnection."
• No exposed "hot" terminals
• Doesn't need ring terminal lugs

Overcurrent protection: DC circuit breakers UL listed for up to 125VDC

• Extremely low voltage drop (less than most fuses or current shunts)
• Rated for interrupting high fault current (up to 25,00 amps at 65 VDC)
• Easy to reset
• No exposed "hot" terminals

Room for expansion

• Optional second main breaker accommodates dual inverter systems
• Second breaker can be field installed
• Space allows for DC current shunts

Optional bonding block simplifies wiring and grounding

• Bonds negative conductor to grounding system at single point
• Lugs to terminate four 4/0, two #1/0, two #2 and four #4 cables

Four Auxiliary breaker positions

• Optional 15-amp DC breaker for small DC loads or equipment room light
• Optional 60-amp DC-rated breaker for PV array disconnect, charge controller, etc.
• UL listed for DC systems up to 125 VDC
• Rated for interrupting high fault current, up to 25,000 amps at 65 VDC
• Easily accessible #10-32 stud terminal